Skip to main content

3D print check

Drop an STL or 3MF and get the numbers a slicer worries about: is the surface closed, how many bodies, how thin the thin walls are, how much of it hangs over nothing, and which way up to print it. Measured in this tab; the file is never uploaded.

Drop an STL or 3MF here

or choose a file. Binary or ASCII STL, 3MF, up to 32 MB.

Parsed and measured in this tab. Nothing is uploaded, no account is needed.

Drag to turn · scroll to zoom · double-click to reset

Thin wall, open edges, too much support?Describe the change and ChatCAD rebuilds the part with a real CAD kernel — then you can check it again here.Describe the change

What is measured

Watertight, and how many bodies

Every edge must be shared by exactly two triangles. An open edge is a hole a slicer has to guess at; several closed bodies print as several islands.

Wall thickness, by ray casting

Area-weighted points on the surface fire a ray inward and measure the first exit. It reports the minimum and the 5th percentile, because one bad ray should not condemn a part — and a thin wall that is 5% of the surface is a real risk.

Overhang and support

A face counts when it points down, sits above the build plate, and is flatter than the angle limit (45° by default). The support estimate projects those faces down to the plate.

Orientation

The same measurements for six axis-aligned orientations. The preview always shows the file as uploaded; the table tells you what turning it would buy.

Units and limits

STL carries no units; 3MF does, and this page honours it. An STL is assumed to be millimetres, and the page says when the size suggests otherwise. Files are measured up to four million triangles; the check takes a fraction of a second for a part and a few seconds for a dense mesh.

What it does not do

  • It does not slice, and it does not predict print time, filament or failure.
  • No repair. An open mesh is reported, not stitched back together — the fix belongs in CAD.
  • Wall thickness is sampled, not exhaustive: a very small thin spot can fall between rays.

Is my file uploaded?

No. The STL or 3MF is read and measured with JavaScript in this tab. There is no upload request.

Why does it say my part is not watertight?

At least one edge is used by a single triangle — a hole, a missing face, or a crack between two shells. Slicers often patch small holes silently; this page does not.

Is the wall thickness the same number the slicer shows?

No. It is a ray-cast sample of the solid, not a slicer shell analysis. Use it to find a suspicious thin area, not to certify a wall.

Why is the bottom of my part not an overhang?

The lowest face is assumed to rest on the build plate, so it is not overhanging. Faces above it that point down are.

Which file should I use, STL or 3MF?

3MF when you have it: it carries units and is what a slicer prefers. STL is the fallback, and it is unitless.