Gear generator
Design a spur gear from a few numbers: real involute flanks, an instant profile, and three downloads — DXF for a laser, SVG for a drawing, STL for a printer. No account, no upload.
Pitch Ø
40.00 mm
Outside Ø
44.00 mm
Root Ø
35.00 mm
Base Ø
37.59 mm
Circular pitch
6.28 mm
Tooth thickness
3.14 mm
Contact ratio
1.56
Diametral pitch
12.70
Everything is generated in this tab. Nothing is uploaded and no account is needed.
A gear is a part. The gearbox is the part you need?Describe the pair, the shaft or the housing and ChatCAD builds it with a real CAD kernel.Describe the gearboxWhat the profile is
Each flank is the involute of the base circle, sampled at 14 points per flank so a laser or a printer sees a smooth curve. The tooth thickness comes from the standard formula with profile shift, the root is an arc at the root radius, and the tip is capped when the addendum would make the tooth pointed. Below the base circle the flank is drawn as a short straight line with a few thousandths of a radian of lean — an approximation, and the reason there is no fillet at the root.
Which file for what
DXF
The cut outline plus the bore, one unit per millimetre. Layers: GEAR, BORE, REFERENCE.
SVG
The same profile at real size, for a drawing, a doc or a quick check.
STL
The gear extruded to the thickness you set, watertight, ready for a slicer.
What it does not do
- Spur gears only. No helical, internal or bevel gears, and no gear pairs.
- No true trochoidal root fillet, no backlash allowance, no tip chamfer.
- It does not check strength, wear or noise — those need a load case and a material.
Privacy
Everything is generated in this tab. Nothing is uploaded and no account is needed.
Questions
Is this a real involute gear?
The flanks are the involute of the base circle, sampled from the geometry rather than drawn as arcs. Tip and root are arcs; below the base circle the flank is a short straight approximation.
What is profile shift for?
Positive shift moves the tooth outward, which avoids undercut on small gears. It changes the outside diameter and the tooth thickness; the centre distance in the readout assumes two identical shifted gears.
Why is my gear flagged as undercut?
With a 20° pressure angle an unshifted gear needs about 17 teeth for the tool not to cut the root. Fewer teeth, or a smaller pressure angle, needs profile shift.
Can I get a STEP file?
Not from this page. The STL is a mesh; ChatCAD’s workspace builds a STEP from a script, and you can describe the gear there to get one.
What thickness should I use?
A common starting point is 6–10× the module for plastic printing, less for metal. It only affects the STL; DXF and SVG are flat.